HARD-DRIVE-DESTROYER.COM

Datagone Hard Drive Degausser
DataGone

High Energy, Automatic Hard Disk Drive and Backup Tape Degausser

For fast and failsafe erasure of large volumes of hard disk drives and back up tapes, the DataGone degausser delivers. It’s automatic operation and powerful magnetic field provides sanitization of hard drives in just 8 seconds which means you can achieve complete erasure of 200 hard drives or back up tapes every hour.

The DataGone is also available with our unique Data Destruction Auditor which enables you to document and verify your hard drive sanitization/erasure and create data protection audit ready reports.

Easy Operation. The DataGone is a fully automatic, table top mounted degausser. Sliding the media into the aperture on the left hand side of the unit automatically starts the degauss cycle. When complete, the media is released and exits from the DataGone on the right hand side. The entire procedure takes just 8 seconds from start to finish.

Throughout the degauss cycle, the on-board processor monitors the procedure and progress messages are displayed on the LCD panel. If the degauss cycle is interrupted for any reason such as power loss or any fault condition, the media is retained in the DataGone and the operator is immediately alerted to the interruption on the LCD panel. When security is of the upmost importance the DataGone’s failsafe operation should be your degausser of choice.

Compliance.The DataGone is designed to help you comply with the following Government Mandates that require destruction of sensitive information stored on Hard Drives and Backup Tapes before their disposal.
•PCI DSS (Payment Card Industry) Data Security Standard
•PIPEDA (Personal Information Protection and Electronic Documents Act)
•NIST (National Institute of Standards and Technology) Guidelines for Media Sanitization NIST SP 800-88
•NIST (National Institute of Standards and Technology) Guidelines for Media Sanitization NIST SP 800-36
•Gramm-Leach-Bliley Act (GLBA)
•HIPAA (Health Information Portability and Accountability Act)
•California SB-1386
•IRS-1075
•CJIS
•Bank Secrecy Act (BSA)


SPECIFICATIONS
Degauss Method: Pulse discharge degausser
Media Handling:
Standard PC, Laptop and Server 3.5", 2.5" & 1.8" Hard Drives. Longitudinal & perpendicular recording. All Drive interfaces IDE, SATA and Fibre Channel.

All Backup tapes including DLT,2,3,4,5,6 & SDLT, LTO1,2,3,4,5,6 & 7; 3480/3490/3490e, 3590, 9840 & T9940 & T10000 tape; Ultrium & Redwood SD-3 tape & cartridges; Mammoth 1 & 2, 8mm, AIT1 & 2,M2 tape; DDS 1, 2, 3, 4 & 5, DD-2

Media Slot Dimensions:
1.1" x 4.3" (279mm x 109.2mm)
Magnetic Force:
10,000 gauss
Cycle Time/Erase Time:
8 seconds typical
Throughput: 200 hard drives/cartridges in one continuous session
Up to 275 hard drives in the first hour
Duty Cycle:
Continuous
Power Supply:
100-120 VAC, 208-240 VAC, 50/60Hz - (Specify voltage and frequency when ordering)
Current Rating:
50Hz 5 Amps, 60Hz 9 Amps
Controls:
On/Off Power switch, Reset button
Dimensions (WxHxD):
14.3" x 19.1" x 14.3" (36cm x 48cm x 36cm)
Unit Weight:
64lbs (29kgs)
Packed Dimensions (WxHxD): 19.5" x 29.1" x 19.5" (50cm x 74cm x 50cm)
Packed Weight: 75lbs (34kg)
Temperature: 41°F - 104°F (5°C - 40°C)
Humidity: 10%H – 40%H Without Condensation
Options: Data Destruction Auditor
Transportation case
Warranty: 12 months back to base, all parts and labor included. Extended warranties also available.
Certifications: CE

 

Specifications are subject to change without notice

Note: After degaussing, hard drives should not be reused as they are stressed in the erasure process. Some backup tapes may not be reusable after degaussing due to the servo track being erased.

 

Contact us~

Powered by w3.css